2. Base course treatment is required for putty powder construction

檢查基面及基層清理，包括清除墻面砂灰結塊、浮砂及塵土，以提高膩?zhàn)臃鄣氖┕っ婊鶎拥钠秸群透街Γ_保基面無污染，無空鼓，無縫隙，無疏松無掉粉現象。

Check the cleaning of the base surface and base course, including the removal of sand and ash caking, floating sand and dust on the wall, to improve the flatness and adhesion of the base course of the putty powder construction surface, and ensure that the base surface is free of pollution, hollowing, cracks, looseness and powder loss.

3、施工溫度要在5℃以上

3. The construction temperature shall be above 5 ℃

施工環境一直都是非常重要的因素，如果環境溫度過低，容易影響到膩?zhàn)又杏袡C(jī)添加劑的溶解，如果添加劑不能充分溶解，或是溶解速度過慢，將影響膩?zhàn)优魏蟮某赡べ|(zhì)量和施工性能。施工環境過熱、過干也不行，膩?zhàn)邮┕みm宜在5℃-35℃的環境下進行。

The construction environment has always been a very important factor. If the ambient temperature is too low, it is easy to affect the dissolution of organic additives in the putty. If the additives cannot be fully dissolved or the dissolution rate is too slow, it will affect the film quality and construction performance of the putty after batching. The construction environment is neither too hot nor too dry. The putty construction should be carried out at 5 ℃ - 35 ℃.

4、膩?zhàn)优魏穸仍?.5mm-1mm之間

4. The thickness of putty is 0.5mm-1mm

膩?zhàn)拥呐尾荒芴∫膊荒芴瘛Ｌ〉脑挘佔訉尤菀资^快導致膩?zhàn)映霈F(xiàn)粉化，終會影響涂裝的效果。而膩?zhàn)訉优蔚迷胶瘢瑒t其干縮強度越大，越容易開裂。因此，單次膩?zhàn)拥呐魏穸群檬窃?.5mm-1mm之間。

The putty shall not be too thin or too thick. If the putty layer is too thin, it is easy to lose water too quickly, which will lead to putty pulverization, and will eventually affect the coating effect. The thicker the putty layer is scraped, the greater its dry shrinkage strength and the easier it is to crack. Therefore, the batch thickness of single putty is better between 0.5mm-1mm.