石膏粉補墻的正確方法主要包括以下步驟：

　　The correct method for using gypsum powder to repair walls mainly includes the following steps:

　　一、準備工具和材料

　　1、 Prepare tools and materials

　　工具：攪拌用的桶或容器、攪拌工具（電動攪拌器或木棒）、抹刀或刮刀、砂紙、刷子等。

　　Tools: mixing buckets or containers, mixing tools (electric mixers or wooden sticks), spatulas or scrapers, sandpaper, brushes, etc.

　　材料：硬度較好的石膏粉（特別是A級別或特級粉）、清水、乳白膠或白乳膠（可選）。

　　Materials: Gypsum powder with good hardness (especially A-grade or special grade powder), water, milk white glue or white latex (optional).

　　二、調配石膏粉

　　2、 Mixing gypsum powder

　　比例：按照水和石膏粉的比例進行調配，通常比例為28:100（即一份水配大約3.57份石膏粉），但具體比例可根據需要的稠度稍作調整。

　　Proportion: Mix according to the ratio of water and gypsum powder, usually in a ratio of 28:100 (i.e. one part of water is about 3.57 parts of gypsum powder), but the specific proportion can be adjusted slightly according to the required consistency.

　　順序：先在容器中倒入適量清水，然后慢慢加入石膏粉，避免一次性倒入過多，防止石膏粉結塊。

　　Sequence: First, pour an appropriate amount of water into the container, then slowly add gypsum powder to avoid pouring too much at once and prevent gypsum powder from clumping.

　　攪拌：用攪拌工具均勻攪拌石膏粉和水，直到形成沒有氣泡、沒有結塊的均勻漿狀。攪拌時間不宜過長，因?yàn)槭喾蹠?huì)迅速凝固。

　　Mixing: Use a mixing tool to evenly mix gypsum powder and water until a uniform slurry without bubbles or clumps is formed. The mixing time should not be too long, as gypsum powder will quickly solidify.

　　三、處理墻面

　　3、 Dealing with wall surfaces

　　清潔：確保修補表面干凈、無油污、無浮塵。對于老化的墻面，可以輕輕打磨或濕潤表面，增強石膏的附著力。

　　Cleaning: Ensure that the repaired surface is clean, free of oil stains and floating dust. For aging walls, gently polish or moisten the surface to enhance the adhesion of gypsum.

　　填補：將調配好的石膏漿填補到墻體的裂縫或坑洞中，填滿后使用抹刀或刮刀輕輕刮平表面。對于較大的裂縫或坑洞，可以多次分層填充，每次填充厚度不宜過厚，等第一層稍干后再進行第二層。

　　Fill: Fill the cracks or holes in the wall with the prepared gypsum slurry, and then gently scrape the surface with a spatula or scraper. For larger cracks or pits, they can be filled multiple times in layers, and the thickness of each filling should not be too thick. Wait until the first layer is slightly dry before proceeding with the second layer.

　　四、修飾和打磨

　　4、 Decorate and polish

　　修飾邊緣：在石膏開始初步硬化但還未完全干透時，可以用濕潤的抹刀輕輕修飾邊緣和表面，使其更加平滑。

　　Trimming the edges: When the plaster is beginning to harden but has not completely dried, a moist spatula can be used to gently trim the edges and surface to make them smoother.

　　干燥：等待石膏漿完全干燥。初凝時間通常為10~20分鐘，但完全干燥可能需要24小時。

　　Drying: Wait for the gypsum slurry to completely dry. The initial setting time is usually 10-20 minutes, but complete drying may take 24 hours.

　　打磨：使用細砂紙打磨石膏表面，使其光滑平整。如果發現有不平或缺陷的地方，可以重新用薄層石膏修補，再次打磨。

　　Polishing: Use fine sandpaper to polish the surface of gypsum to make it smooth and even. If unevenness or defects are found, they can be repaired with a thin layer of gypsum and polished again.

　　五、注意事項

　　5、 Precautions

　　施工環境：確保施工環境干燥、無潮濕。過于潮濕的環境會延緩石膏粉的凝固時間，影響硬度。

　　Construction environment: Ensure that the construction environment is dry and free from moisture. An excessively humid environment can delay the solidification time of gypsum powder and affect its hardness.

　　加膠選擇：如需在石膏粉中加入乳白膠或白乳膠以增強牢固度和光滑度，應注意加入后凝固時間會延長。

　　Glue selection: If you need to add milk white glue or white milk glue to gypsum powder to enhance firmness and smoothness, please note that the solidification time will be prolonged after adding.

　　安全防護：攪拌時避免石膏粉揚起，佩戴口罩防止吸入對呼吸道造成傷害；石膏粉與水混合后可能對皮膚有輕微刺激，建議施工時佩戴手套。

　　Safety protection: Avoid lifting gypsum powder during mixing, wear a mask to prevent inhalation and respiratory injury; Gypsum powder mixed with water may cause slight irritation to the skin. It is recommended to wear gloves during construction.

　　工具清潔：石膏粉凝固后難以清理，施工完成后應立即用清水清洗所有工具，防止石膏干固。

　　Tool cleaning: Gypsum powder is difficult to clean after solidification. After construction is completed, all tools should be immediately cleaned with clean water to prevent gypsum from drying out.

　　按照上述步驟進行石膏粉補墻，可以確保修補效果牢固、美觀。

　　Following the above steps for gypsum powder wall repair can ensure a firm and aesthetically pleasing repair effect.

　　本文由 濟南石膏粉 友情奉獻.更多有關的知識請點擊  http://www.netjobs.cc   真誠的態度.為您提供為全面的服務.更多有關的知識我們將會陸續向大家奉獻.敬請期待.

　　This article is a friendly contribution from Jinan gypsum powder For more related knowledge, please click http://www.netjobs.cc Sincere attitude To provide you with comprehensive services We will gradually contribute more relevant knowledge to everyone Coming soon.